ASDA-M Chapter 8 Parameters
Revision December, 2014 8-71
P1-55 MSPD Maximum Speed Limit
Address: 016EH
016FH
Parameter
Attribute：
Parameter for individual axis
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
Same as the rated speed of each model
Control
Mode：
ALL
Unit：
r/min
Range：
0 ~ max. speed
Data Size：
16bit
Format：
DEC
Settings：
The default of the max. speed of servo motor is set to the rated
speed.
P1-56 OVW Output Overload Warning Level
Address: 0170H
0171H
Parameter
Attribute：
Parameter for individual axis
Related Section: -
Operational
Interface：
Panel / Software Communication
Default：
120
Control
Mode：
ALL
Unit：
%
Range：
0 ~ 120
Data Size：
16bit
Format：
DEC
Settings：
The setting value is 0 ~ 100, if the servo motor continuously
outputs the load and is higher than the setting proportion (P1-56),
the early warning for overload (DO is set to 10, OLW) will occur.
If the setting value is over 100, it will disable this function.
P1-57 Reserved
Address: 0172H
0173H
P1-58 Reserved
Address: 0174H
0175H
To Next Page
Loading...