DVP-ES2/EX2/EC5/SS2/SA2/SX2/SE&TP Operation Manual - Programming
General step. S10 ~ S1023 are applicable.
Step jump. Used for a step to jump to another non-adjacent step. (Jumping
up/down to non-adjacent steps in the same sequence, returning to initial step, or
jumping among different sequences.)
Transition condition. The transition condition to move between each step point
.
Alternative divergence. Alternative divergence is used for a step point to
transfer to different corresponding step points by different transition conditions.
Alternative convergence. Alternative convergence is used for two step points or
more to transfer to the same step point according to transition condition.
Simultaneous divergence. Simultaneous divergence is used for a step point to
transfer to two step points or more by the same transition condition.
Simultaneous convergence. Simultaneous convergence is used for two step
points or more to transfer to the same step point with the same transition
condition when multiple conditions are fulfilled at the same time.
To Next Page
Loading...
