Delta DVP-SS2 User Manual

7 CANopen Function and Operation
7-7
Product
Model
Function
DVPCOPM-SL
DVPCOPM-SL is a module
connected to the left side of an S
series PLC. It can function as the
CANopen master or slave. The PLCs
which can be connected to
DVPCOPM-SL are DVP-28SV,
DVP-28SV2, DVP-SX2, DVP-SA2,
and DVP-EH2-L.
IFD9503
It converts CANopen to the Modbus
gateway, and connects the device
(with the RS-232 or RS-485 interface)
which conforms to the standard
Modbus protocol to the CANopen
network. 15 devices at most can be
connected.
DVPCP02-H2
It is the CANopen slave module, and
is connected to the right side of an
EH2 series PLC. It can connect the
EH2 series PLC to the CANopen
network.
IFD6503
It is a tool used to analyze the
CANopen network data. The
interfaces at both ends are the CAN
interface and the USB interface. It
can be used to catch the CAN
network data, or allow the CAN nodes
to transmit the data. The product is
used with the software Netview
Builder.
ASD-A2-xxxx-M
servo driver
It is a servo driver with the built-in
CANopen interface. It controls the
positioning, speed, and torque.
C2000/CP2000/C200 series
AC motor drives
It is an AC motor drive with the
built-in CANopen function, and
controls the positioning, speed, and
torque. Before using the CANopne
function of the C2000/CP2000 series
AC motor drives, users need to
purchase CMC-COP01. This card
only provides the CAN interface. The
C200 series AC motor drive has the
built-in CANopen interface.

Delta DVP-SS2 Specifications

General

Brand	Delta
Model	DVP-SS2
Category	Controller
Language	English