EasyManuals Logo

Delta Paxos User Manual

Delta Paxos
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
44
Push in the center of the acrylic wall anchor (G1) and
squeeze clips together. Insert acrylic wall anchor (G1) into
hole.
If needed, a rubber mallet can be used to insert acrylic wall
anchors (G1).
If needed, use drill to slightly enlarge the opening of the hole.
NOTE: Acrylic wall anchors (G1) MUST be used.
Repeat steps 60a-61a for other end of enclosure.
Empuje el centro del anclaje acrílico de pared (G1) y apriete
las abrazaderas juntas. Inserte el anclaje acrílico de pared
(G1) en el orificio.
Si es necesario, se puede utilizar un martillo de goma para
insertar los anclajes acrílicos de pared (G1).
De ser necesario, utilice la broca para ampliar un poco la
abertura del orificio.
NOTA: DEBE utilizar los anclajes acrílicos de pared (G1).
Repita los pasos 60a-61a para el otro extremo del recinto.
1
1/4"1/4"
2
1
60b
Z1
1
2
9
G1
61a
G1
3
CAUTION
PRECAUCIÓN
CAUTION
PRECAUCIÓN
CAUTION
To avoid risk of injury or product damage, make sure that
you drill into studs.
PRECAUCIÓN
Para evitar el riesgo de lesiones o daños al producto,
asegúrese de perforar en los montantes.
CAUTION
Wear safety glasses and gloves when drilling or cutting
to avoid risk of injury.
PRECAUCIÓN
Use gafas de seguridad y guantes cuando perfore o corte
para evitar lesiones.
Use cut-resistant gloves with appropriate grip to avoid
risk of injury from sharp edges or corners.
Use guantes resistentes a los cortes con el agarre
apropiado para evitar el riesgo de lesiones por los bordes
y esquinas afiladas.
To avoid risk of injury or product damage, DO NOT remove
corner protectors on the glass panel(s) until the panels are
installed.
Para evitar el riesgo de lesiones o danos al producto NO quite
los protectores de las esquinas en el panel o paneles de vidrio
hasta que estos esten instalados.
After removing grab bumper (Z1) from the wall and
using a tile bit, drill a 1/4" hole at location marked in the
previous step.
Después de quitar el asidero (Z1) de la pared y usando
una broca para baldosas, perfore un orificio de 1/4" en la
ubicación marcada en el paso anterior.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Delta Paxos and is the answer not in the manual?

Delta Paxos Specifications

General IconGeneral
BrandDelta
ModelPaxos
CategoryBathroom Fixtures
LanguageEnglish

Related product manuals