What does 'Grid Quality' error mean on Delta RPI H3A?
The 'Grid Quality' error on your Delta Inverter indicates a non-linear load in the Grid close to the inverter. The grid connection of the inverter needs to be away from non-linear loads if necessary.
What to do if my Delta Inverter shows 'No Grid' error?
If your Delta Inverter displays the error 'E09: No Grid', first, ensure the AC breaker is switched on. Next, verify the AC plug connection to the inverter. Finally, if the problem persists, replace the fuses and inspect all switching devices in the boost and inverter stages. The possible causes are: the AC breaker being OFF, the AC plug being disconnected, or internal fuses being broken.
What to do if my Delta RPI H3A displays 'Grid Volt Under Rating'?
If the Delta Inverter shows 'E10: Grid Volt Under Rating', first measure the utility AC voltage at the inverter terminal and check the connection. Also, verify the country and grid settings. If the issue continues, check the detection circuit inside the inverter. The possible causes include: the actual utility voltage being under the UVR setting, the utility voltage being under the Slow UVR setting during operation, incorrect country or grid settings, or a detection circuit malfunction.
Why is my Delta RPI H3A Inverter showing 'Grid Freq. Over Rating'?
If your Delta Inverter is showing 'E01: Grid Freq. Over Rating', check the utility frequency on the inverter terminal. Also, verify the country setting. If the issue persists, check the detection circuit inside the inverter. This might be happening because the actual utility frequency is higher than the OFR setting, the country setting is incorrect, or there's a detection circuit malfunction.
What to do if my Delta RPI H3A Inverter displays 'NTC Over Temp'?
If your Delta Inverter shows 'NTC Over Temp', it could be because the ambient temperature is above 60°C or due to a detection circuit malfunction. Check the installation ambient temperature and environment. Also, check the detection circuit inside the inverter.
What does 'Heat Sink NTC1 Fail' mean on my Delta RPI H3A?
If your Delta Inverter displays 'Heat Sink NTC1 Fail', it could be because the boost heat sink temperature is greater than 100°C or less than -24°C, or due to a detection circuit malfunction. Check the installation ambient and environment. Also, check the detection circuit inside the inverter.
Why does my Delta RPI H3A Inverter show 'Grid Freq. Under Rating'?
If your Delta Inverter displays a 'Grid Freq. Under Rating' error, it could be due to a few reasons. First, check the utility frequency on the inverter terminal. Second, check the country and grid settings. Finally, there may be a detection circuit malfunction inside the inverter.
How to fix 'Slow Over Voltage Range' error on Delta RPI H3A Inverter?
If your Delta Inverter displays a 'Slow Over Voltage Range' error, it could be due to a few reasons. First, check the utility voltage on the inverter terminal. Second, check the country and grid settings. Finally, there may be a detection circuit malfunction inside the inverter.
What causes the 'NTC Over Temp' error on my Delta Inverter?
If your Delta Inverter is displaying 'F05: NTC Over Temp', check the installation ambient temperature and environment. If the issue persists, check the detection circuit inside the inverter. This could be caused by the ambient temperature being above 60°C or a detection circuit malfunction.
What should I do if my Delta Inverter shows a 'Ground Fault' error?
If your Delta Inverter displays 'E34: Ground Fault', check the insulation of the solar inputs. Also, check the capacitance and dry the PV panel if necessary. If the issue persists, check the detection circuit inside the inverter. This could be caused by a PV array insulation fault, large PV array capacitance between Plus to Ground or Minus to Ground or both, or a detection circuit malfunction.
To Next Page
General
