2 Installation and Wiring
2.1 Instruction before Installation
Due to the variety of users and installation environments, it is recommended to read
this manual thoroughly before installation. Installation of the unit and start-up procedures
must be carried out by accredited technicians.
Upon receiving your brand new RPI inverter, you will be required to remove its protective
packaging. This packaging consists of various materials that will need to be disposed of
according to the specific recycling marking printed on them. Please note that cardboard
may be recycled, whereas polystyrene foam may not. Please dispose of the packaging
materials in a correct manner to ensure a better environment for us all.
2.2 Unpacking
Unpacking process is shown as Figure 2-1.
Figure 2-1: Unpacking process
9
Installation and Wiring
To Next Page
Loading...
