Delta Electric Servo Press - S Series
Installation and Maintenance Instructions
13
4.3 Repair
4.3.1 AM-ESP-S005-XXXX / AM-ESP-S010-XXXX Standard
Type
The fastening ports for attaching the servo press are shown in the figure below. Please use 4 general
M10X1.5 hex screws (JIS strength 12.9, length 45) and apply the tightening torque of 663 kgf-cm.
Caution: Please note that the equipment has to be closely attached to the locking and fastening platform
while fastening the servo press.
To Next Page
Loading...
