Delta Electric Servo Press - S Series
Installation and Maintenance Instructions
14
4.3.2 AM-ESP-S030-XXXX / AM-ESP-S050-XXXX Standard
Type
The fastening ports for attaching the servo press are shown in the figure below. Please use 4 general
M20X2.5 hex screws (JIS strength 12.9, length 80) and apply the tightening torque of 5600 kgf-cm.
Caution: Please note that the equipment has to be closely attached to the locking and fastening
platform while fastening the servo press.
To Next Page
Loading...
