20 21
DEPTH STOP ADJUSTMENT
This mitre saw is equipped with an adjustable depth stop
for making through cuts and non-through cuts.
Refer to Figure 28 and follow these instructions in
order to set the depth stop at a specific cut depth:
use a Phillips head screwdriver to loosen screw (E) and
then rotate the stop bracket (D) counterclockwise into
the down position. Make sure to re-tighten screw (E).
The cut depth can now be adjusted by turning the depth
adjustment screw (C).
Refer to figure 28 and follow these instructions
in order to make a through cut: use a Phillips head
screwdriver to loosen screw (E) and then rotate the stop
bracket (D) clockwise into the up position. Make sure to
re-tighten screw (E).
Always check to make sure screw (E) is
tightened before making a cut. Failure to
do so may result in injury.
FIGURE 28
C
D
E
LASER OFFSET ADJUSTMENT
If you notice the laser line is offset from the actual cut line
refer to Figure 27 and follow these instructions: using a
Phillips head screwdriver turn the screw (B) to adjust the
offset.
B
LASER VERTICAL ANGLE
ADJUSTMENT
If you notice the laser line does not remain parallel to the
blade as the saw head is lowered to make a cut refer to
Figure 26 and follow these instructions: using a Phillips
head screwdriver turn the screw (A) to adjust the vertical
angle of the laser.
FIGURE 26
A
FIGURE 27
ADJUSTMENTS
To Next Page
Loading...
