49
Reset / restart operation may be performed up to 10 times after a fault has occurred.
Setting this parameter to 0 disables the reset / restart operation after any fault has
occurred. If a protective shut-down operation (oc, ov) occurs during operation, the
auto reset / restart function can be selected. (Refer to Fault Names in Ch. 7)
Pr.73 Pr.74 Pr.75
Fault Records
Parameter # 73, 74, 75
Parameter Name
Three most recent fault records
Factory Setting
d0000
Settings
d0000
d0001 Over-current (oc)
d0002 Over-voltage (ov)
d0003 Overheat (oH)
d0004 Overload (oL)
d0005 Overload 1 (oL1)
d0006 External fault (EF)
d0007 CPU failure 1 (CF1)
d0008 CPU failure 3 (CF3)
d0009 Hardware protection failure (HPF)
d0010 Over-current during acceleration (ocA)
d0011 Over-current during deceleration (ocd)
d0012 Over-current during steady state operation (ocn)
d0013 Ground fault or fuse failure (GFF)
d0014 Manufacturer-used diagnostics
d0015 Manufacturer-used diagnostics
d0016 Manufacturer-used diagnostics
d0017 External baseblock (bb)
d0018 Overload 2 (oL2)
d0019 Manufacturer-used diagnostics
d0020 Manufacturer-used diagnostics
These parameters store records of the three most recent faults that have occurred.
Pr.76
Keypad Lockout / Reset
Parameter # 76
Parameter Name
Keypad Lockout / Reset
Factory Setting
d0000
Settings
d0000 All parameters can always be set and read
d0001 All parameters are read-only
d0002 - d0009 Not used
d0010 Resets all parameters to the factory defaults
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
Need help?
General