Chapter 7 Optional AccessoriesMS300
143
7-14-4 Digital Keypad KPC-CC01 Fault Codes and Descriptions
Fault Codes
Flash memory
read error
(FrEr)
Keypad flash memory
read error
Error in the keypad’s flash memory.
1. Press RESET to clear the errors.
2. Check for any problem on Flash IC.
3. Shut down the system, wait for ten
minutes, and then restart the system.
If none of the above solutions works,
contact your authorized local dealer for
assistance.
Flash memory
save error
(FsEr)
Keypad flash memory
save error
Error in the keypad’s flash memory.
1. Press RESET to clear the errors.
2. Check for any problem on Flash IC.
3. Shut down the system, wait for ten
minutes, and then restart the system.
If none of the above solutions works,
contact your authorized local dealer for
assistance.
Flash memory
parameter error
(FPEr)
Keypad flash memory
parameter error
Error in the default parameters.
It might be caused by a firmware update.
1. Press RESET to clear the errors.
2. Check for any problem on Flash IC.
3. Shut down the system, wait for ten
minutes, and then restart the system.
If none of the above solutions works,
contact your local authorized dealer for
assistance.
Reading AC
motor drive data
error
(VFDr)
Keypad error when
reading AC motor drive
data
Keypad cannot read any data sent from the
VFD.
1. Verify that the keypad is properly
connected to the motor drive by a
communication cable such as RJ45.
2. Press RESET to clear the errors.
3. Shut down the system, wait for ten
minutes, and then restart the system.
If none of the above solutions works,
contact your local authorized dealer for
assistance.
A serious error in the keypad’s CPU.
1. Check for any problem on CPU clock.
2. Check for any problem on Flash IC.
3. Check for any problem on RTC IC.
4. Verify that the communication quality
of the RS-485 cable is good.
5. Shut down the system, wait for ten
minutes, and then restart the system.
If none of the above solutions works,
contact your local authorized dealer for
assistance.