TT-2000, TTD-2000, TT-4000 Ticket Eaters™ by Deltronic Labs June 2019
Holes-only (non-barcoded) tickets should not have bold graphics or borders in the
reserved center area. Other graphics can be printed there, but solid bold graphics can
appear to be a hole to sensors which use light reflected from the tickets. This can cause
in miscounts.
Tickets with Bold Printing in the Reserved Area
Later versions of the Ticket Eater can handle half-size 1 inch long tickets. These tickets
are the same width as standard tickets, but only 1 inch long. They have the same holes
and notches as standard tickets. Option 28 in the Ticket Eater selects the ticket size.
Barcoded half-size tickets use a shorter version of the barcode used on standard tickets.
This barcode encodes 2 digits instead of 4 digits. It uses the same interleaved 2 of 5
code. This gives it 9 bars and 8 spaces. There are 12 thin bars/spaces and 5 thick
bars/spaces. Thick bars/spaces are 3 times as wide as thin bars/spaces.
The barcode bars should be printed with a dark color (black is preferred). The ink should
be dense enough that no background color shows through the bars
The barcode must be printed on both sides of the tickets.
The barcode background color should not be a dark color such as dark brown, dark blue,
dark gray, etc.
The guidelines for standard holes-only tickets also apply to 1 inch holes-only tickets.
To Next Page
Loading...