TT-2000, TTD-2000, TT-4000 Ticket Eaters™ by Deltronic Labs June 2019
Changing Options Without Software
DL Ticket Eater Manager software (sold
separately) is the preferred way to manage
your TT-2000 Ticket Eater with AP-100
main logic board. The previous section of
this manual covers that. Some settings can
also be changed without the software by
using buttons inside the TT-2000. This
section covers those procedures. Changing
any of the words printed on the receipt can
only be done with the software.
These procedures use the red and black buttons mounted in front of the logic board, the
SW1 button on the logic board, and the display on the door. The RUN/PRG jumper is not
used. It must stay in the RUN position. Leaving the jumper in the PRG position will
drain the battery. To enter the options mode:
1. Open the top door of the Ticket Eater.
2. Pull out the safety switch. This turns the Ticket Eater on with the door open. The
red and green LED’s on the main logic board should be on.
3. Wait for the display to finish the power-up test.
4. Push the SW1 button.
5. The display will show 99 0. You are now in Options Mode.
In Options Mode the first number (99 in this case) shows the number of the option that
you are working with. The second number (0 in this case) shows the option’s value.
Press the red or black button to change the value. Press both buttons at the same time to
accept the currently displayed value and advance to the next option.
Accept the value & Advance to the next option
The options are organized into groups. 99 is a special number which indicates that you
are selecting a group of options to work with. When you select a group, the first option
in that group is displayed. As you accept each option by pressing both buttons together,
the next option is displayed. After the last option you are returned to 99 to select another
group. If you turn off the machine before you return to 99, your changes will be lost.
1 to 7(Sunday to Saturday)
To Next Page
Loading...