TT-2000, TTD-2000, TT-4000 Ticket Eaters™ by Deltronic Labs June 2019
If you set option 26 to 0 or 3 and you are not using a full bucket sensor, it will
disable the “Bin Full” message.
If you empty the trash can before the full count is reached, reset the bucket count
with Function Mode 3 (see the section “Performing Functions without Software”)
or with the DL Manager software.
Machines with card swipe systems may also show these messages:
1. Full Count – Scan Card or Print
The maximum possible count is limited by the number of digits in the door
display. When this count is reached, the Ticket Eater will stop and display this
message. After the card is scanned or a receipt is printed the Ticket Eater will
return to normal operation.
2. Sending Data
This is a normal informational message.
3. Data Send Error – Call for Help
Problems with the card swipe system or the communication between the card
swipe system and the logic board will cause this message. Fix the problem and
re-start the Ticket Eater.
To Next Page
Loading...