C-110-170-200E R11 Page 5
Prepare the water supply for the High Pressure Cleaner by attaching a
hose to the supplied low pressure inlet male-coupling. Connect the other
end of the water supply hose to a potable water tap. Turn on tap.
Connect to the public mains water supply in accordance to
regulations.
Before starting the machine, bleed out air by pulling the trigger-gun handle until any air has
escaped the inlet hose. Release trigger once water flow is smooth at the outlet.
Put the power-plug into a main power supply socket. Turn on the power of
the High Pressure Cleaner by turning the knob clockwise to the ON
position.
The high pressure cleaner is now ready for
operation. The spray-gun lance is affected by a
recoil force during operation – therefore keep a
firm grip with both hands on the Spray-gun handle
and the lance. Press the trigger and tighten pressure
regulating knob to achieve maximum pressure for
effective cleaning.
The pressure can be regulated by turning the knob on the spray-gun
lance. Tighten knob for maximum pressure and loosen for low pressure
washing. When using chemical injector, pressure must be adjusted to
low.
Make sure your local power supply specifications are in accordance with the
motors requirement. Refer to the ID-plate on the machine. Do NOT run the
High Pressure Cleaner without sufficient potable water supply as it can cause
cavitation and serious damage to internal pump parts. Do not let the machine
recycle the water (running with Spray-gun trigger not activated) for more than
a minute. This can cause serious damage to the seals.
CAUTION
Notice
Pressure Regulating Knob
Depress Trigger
Knob fully tighten
To Next Page
Loading...
