Denon ADV-1000 - Setting the Current Time (12-Hour Display); Using the Timer

69
ENGLISH
(1) Setting the current time (12-hour display)
Example: To set the current time to “7:30 p.m.”
19
USING THE TIMER
1
Turn on the power.
ON / STANDBY
Main unit
2
Press the TIMER/SET button and hold it in for at least 2
seconds.
•“SET TIME” is displayed.
TIMER/SET
Main unit
If the time is already set, “EVERYDAY” is displayed. Turn
the FUNCTION/SELECT dial to display “SET TIME”, then
continue on to step 3.
3
Press the TIMER/SET button.
•“Adj” is displayed and the hours’ place in the time display
flashes.
SET TIME
Adj. AM12:00
TIMER/SET
Main unit
4
Turn FUNCTION/SELECT dial to set the hours’ place to
“PM7”.
• The “PM7” flashes in the hours’ place.
Adj. PM7:00
FUNCTION
/ SELECT
Main unit
5
Press the TIMER/SET button.
• The “PM7” in the hours’ place stops flashing, remaining lit,
and the minutes’ place starts flashing.
Adj. PM7:00
TIMER/SET
Main unit
6
Turn the FUNCTION/SELECT dial and set the minutes’ place
to “30”.
• The “30” flashes in the minutes’ place.
Adj. PM7:30
FUNCTION
/ SELECT
Main unit
7
Press the TIMER/SET button to start the clock running.
• The time is set and the clock starts counting the time.
Time PM7:30
TIMER/SET
Main unit
To check the current time when something else is displayed, press
the TIMER/SET button once. The current time appears and
remains displayed until another operation is performed.
When the TIMER/SET button is pressed again while the time is
displayed, after which the normal display reappears.
The time can be displayed by pressing the TIMER/SET button
while the power is in the standby mode. (The power is now no
longer in the energy-saving standby mode.) When the TIMER/SET
button is pressed again while the time is displayed, after which the
display turns off and the power is set back to the energy-saving
standby mode.
2,3,5,71
4,6
Green
Downloaded From Disc-Player.com Denon Manuals