79
ENGLISH
(4) “AUDIO SETUP” is selected
3
Use the and cursor buttons to select the
desired setting, then press the ENTER button.
• DIGITAL OUT
Use this to select the digital output’s signal format.
• LPCM SELECT (96 kHz
/
48 kHz)
Use this to set the digital audio output when playing
DVDs recorded in linear PCM audio.
To exit the audio setup mode
Use the and cursor buttons to select
“DVD SETUP MENU”, then press the ENTER
button.
• The screen returns to as it was in step 2.
Use the and cursor buttons to select the
desired setting, then press the
ENTER button.
2
When “DIGITAL OUT” is selected.
• NORMAL (Factory default)
Make the selection when playing back in surround
playback a DVD that has been recorded with Dolby
Digital or DTS on this unit.
The Dolby Digital or DTS digital signal is also output
from the digital output jacks.
• PCM
DVDs that were recorded in Dolby Digital are
converted to linear PCM 48 kHz/16 bit (2 channels).
Make the selection when making a digital recording.
DVDs recorded with DTS are not converted and
digital recording is not possible.
To exit the digital out mode
Press the ENTER button, you can go back to the
To Next Page
Loading...
