EasyManuals Logo

Denon AVR-1603 User Manual

Denon AVR-1603
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
DENON and other makes of components can be operated by setting the preset memory.
Thus remote control unit can be used to operate components of other manufacturers without usrng the learning function by registering the
manufacturer of the component as shown on the List of Preset Codes (pages 104-I 081
Operation is not possible for some models.
Set mode swatch 1 to “AUDIO” or “VIDEO”
Set the AUDIO srde for the CD, Tape deck or CDWMD
posrtion, to the VIDEO side for the DVDiVDP, DBSKABLE,
VCR or TV positron.
2
Set mode switch 2 to the component to be registered
CD&/~~ lTAPE
D
DvD'vDpa GLXE
AA
3
Press the ON/SOURCE button and the OFF button at the
same time.
l lndtcator flash
Referring to the included List of
Preset Codes, use the number
buttons to input the preset code (a
@ @ @
s-digit
number)
for the
manufacturer of the component
whose signals you want to store in
the memory.
5
To store the codes of another component in the memory,
repeat steps 1 to 4.
-
NOTES:
l The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control
unit’s transmitting window whrle setting the preset memory.
l Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed on the
included list of preset codes.
l Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and
check.
l The preset memory can be set for one component only among the following: CDWMD, DVD/VDP and DBWCABLE.
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR.. ...................................................
HITACHI
CD, TAPE..
............................................. DENON
CDR/MD .................................................
DENON
(CDR)
DVD/VDP .............................
................. DENON
(DVD)
DBSKABLE .............................................
ABC (CABLE)
25

Other manuals for Denon AVR-1603

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-1603 and is the answer not in the manual?

Denon AVR-1603 Specifications

General IconGeneral
Output level47000 mV
Receiver typeSurround
Frequency range10 - 10000 Hz
Input sensitivity200 mV
Audio output channels5.1 channels
Signal-to-Noise Ratio (SNR)96 dB
Total Harmonic Distortion (THD)0.8 %
Power output per channel (1KHz@6 Ohm)110 W
Power output per channel (20-20KHz@8 Ohm)80 W
HDMI in0
AC (power) inYes
Composite video in4
S-Video inputs quantity3
Digital audio coaxial in1
Component video (YPbPr/YCbCr) in2
Connectivity technologyWired
Speakers connectivity type-
AM band range520 - 1710 kHz
FM band range87.5 - 107.9 MHz
Supported radio bandsAM, FM
Preset stations quantity40
Optical drive includedNo
AC input voltage120 V
AC input frequency60 Hz
Product colorBlack
Audio decodersDTS, Dolby Pro Logic II
Apple docking compatibilityNot supported
Weight and Dimensions IconWeight and Dimensions
Depth417 mm
Width434 mm
Height147 mm
Weight10400 g

Related product manuals