1
Select the input source to be played
Example: CD
2
Select the input mode.
l Selecting the analog mode
Press the ANALOG button to switch to the analog input
IMan unftl
mTrlote corltrol UnItI
l Selecting the external input (EXT. IN) mode
Press the EXT. IN (or the EXT. IN button on the remote
control unit) to switch the external input.
CMain unitl
Viemote control unItI
l Selecting the AUTO, PCM and DTS modes
The mode switches as shown below each time the INPUT
MODE button is pressed.
AUTO - PCM - DTS
t
3-
l-
2-
Input mode selection function
Different input modes can be selected for the drfferent Input sources.
The selected input modes for the separate input sources are stored
rn the memory.
a AUTO (All auto mode)
In this mode, the types of signals being Input to the digital and
analog Input jacks for the selected input source are detected and
the program in the thus unrt’s surround decoder is selected
automatically upon playback. This mode can be selected for all
input sources other than TUNER.
The presence or absence of digital signals is detected, the signals
input to the digital input jacks are Identified and decoding and
playback are performed automatically in DTS, Dolby Digital or
PCM (2 channel stereo) format. If no digital signal IS being input,
the analog input jacks are selected.
Use this mode to play Dolby Digital signals.
a PCM (exclusive PCM signal playback mode)
Decoding and playback are only performed when PCM signals are
being input.
Note that noise may be generated when using this mode to play
signals other than PCM signals
@I DTS (exclusive DTS signal playback mode)
Decoding and playback are only performed when DTS srgnals are
being input.
@ ANALOG (exclusive analog audro signal playback mode)
The signals input to the analog Input jacks are decoded and
played.
@ EXT. IN (external decoder Input jack selection mode)
The signals being input to the external decoder input jacks are
played without passing through the surround circuitry,
NOTE:
l Note that noise will be output when CDs or LDs recorded in DTS
format are played in the “PCM” (exclusrve PCM signal playback) or
“ANALOG” (exclusive analog audio signal playback) mode. Select
the AUTO or DTS (exclusive DTS signal playback) mode when
playing signals recorded in DTS from a laser disc player.
Notes on playing a source encoded with DTS
l Noise may be generated at the beginning of playback and
while searching during DTS playback in the AUTO mode. If
l In some rare cases the noise may be generated when you
preform the operation to stop playback of a DTS-CD or DTS-LD.
30
To Next Page
Loading...
Need help?
General
Weight and Dimensions
