3
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Setup Wizard PlaybackPreparation
Connect this unit to the television using an HDMI cable
(sold separately)
NOTE
If this unit is connected using cables other than the HDMI cable, the Setup Wizard
will not be displayed.
(ARC)
HDMI IN
2
Turn the television power on, and switch the video input to
this unit (HDMI input)
For details on how to operate the television, see the television instruction manual.
q Power on
w Switch the input to this unit (HDMI input)
3
Insert the provided batteries into the remote control unit
q Slide the rear lid in the direction of the arrow and remove it.
w Load the two batteries properly as indicated by the marks in the battery compartment.
R6/AA
e Put the rear cover back on.
4
vStart Setup Wizard on next page
To Next Page
Loading...
Need help?
General
