To Next Page
M
Makayla GreenAug 19, 2025
Why is there no sound from my Denon Stereo Receiver speakers?
Why is there no sound from my Denon Stereo Receiver speakers?
General| HDMI Inputs | 2 |
|---|---|
| HDMI Outputs | 1 |
| Dolby Digital | Yes |
| DTS | Yes |
| AM/FM Tuner | Yes |
| Response Bandwidth | 10 Hz - 100 kHz |
| Signal-To-Noise Ratio | 98 dB |
| THD | 0.08% |
| Input Impedance | 47 kOhm |
| Input Sensitivity | 200 mV |
| Tuner Type | Digital |
| Preset Station Qty | 56 |
| HDMI Switching | Yes |
| Tuning Range | FM: 87.5 - 108 MHz, AM: 522 - 1620 kHz |
| Audio D/A Converter | 24-bit / 192 kHz |
| Output Impedance / Channel | 8 Ohm |
| Frequency Response | 10 Hz - 100 kHz |
| Channels | 7.1 |
| Power Output | 75W per channel (8 ohms, 20Hz-20kHz, 0.08% THD) |
| Output Power / Channel | 75W (8 ohms) |
Read and follow all safety and operating instructions for product use and maintenance.
Important guidelines for safe handling, moving, and installation to prevent damage or hazards.
Basic examples and recommendations for installing speakers for optimal sound.
Step-by-step instructions for properly connecting speaker cables to terminals.
How to connect a monitor, including notes on component video connectors.
Guide for connecting DVD players, including video and audio signal routing.
Instructions for connecting a CD player using optical or analog audio cables.
How to connect an iPod using a DENON Control Dock (sold separately).
Guide for connecting a TV or cable tuner for audio and video signals.
Instructions for connecting a Video Cassette Recorder for recording purposes.
Steps for connecting CD recorders, MD recorders, or tape decks.
How to connect video cameras or game consoles to the unit.
How to connect devices with multi-channel analog audio outputs.
Guide for connecting the XM Mini-Tuner and Home Dock for XM Satellite Radio.
Information on setting up multi-zone playback and connecting remote control units.
Steps for connecting the power cord and notes on using AC outlets.
Details on adjusting various sound parameters for optimal playback.
Guide on how to navigate and change settings within the system setup menu.
Setting speaker sizes (Large/Small) and subwoofer use for optimal bass reproduction.
Selecting low-frequency signal reproduction for the subwoofer (LFE/LFE+Main).
Measuring and setting the distance from the listening position to each speaker.
Using test tones to adjust channel levels for equal speaker volume.
Selecting and assigning input sources, including HDMI and digital inputs.
Assigning HDMI and digital input connectors to specific sources.
Assigning the Control Dock for iPod to a specific input source.
Defining amplifier use for surround back channels or multi-zone playback.
Choosing standard playback and surround modes for 2-channel sources.
Decoding and playing multi-channel formats like Dolby Digital and DTS.
Adjusting parameters like D.COMP, LFE, CENTER WIDTH, DELAY TIME, and EFFECT LEVEL.
Configuring amplifiers for different channels for multi-zone or 7.1-channel playback.
