Denon AVR-1508 User Manual

0
Getting Started Connections Remote Control Multi-Zone Information Troubleshooting
ENGLISH
Dialogue normalization function
This is automatically activated when playing Dolby Digital sources.
This function automatically corrects the standard signal level for
individual program sources.
The correction value can be checked using the STATUS button.
O f f s e t - 4 d B
The figure is the correction value when the standard level is
corrected.
[Items to be checked]
Surround Mode
: The currently set surround mode is displayed.
SIGNAL
: The input signal type is displayed.
fs
: The input signal’s sampling frequency is
displayed.
Format
: The number of channels in the input signal (front,
surround, LFE) is displayed.
Offset
: The dialogue normalization correction value is
displayed.
s Audio Input Signal
Shows information about audio input signals.
Information
a Status
Shows information about settings for main zone.
The items displayed differ according to the input source.
Information can be called out directly by pressing the STATUS button.
[Items to be checked]
Surround Mode Select Source Video Select
Digital Assignment TONE DEFEAT Channel Level
etc.
a Status
s Audio Input Signal
PlaybackSetup

Denon AVR-1508 Specifications

General

HDMI Inputs	2
HDMI Outputs	1
Dolby Digital	Yes
DTS	Yes
AM/FM Tuner	Yes
Response Bandwidth	10 Hz - 100 kHz
Signal-To-Noise Ratio	98 dB
THD	0.08%
Input Impedance	47 kOhm
Input Sensitivity	200 mV
Tuner Type	Digital
Preset Station Qty	56
HDMI Switching	Yes
Tuning Range	FM: 87.5 - 108 MHz, AM: 522 - 1620 kHz
Audio D/A Converter	24-bit / 192 kHz
Output Impedance / Channel	8 Ohm
Frequency Response	10 Hz - 100 kHz
Channels	7.1
Power Output	75W per channel (8 ohms, 20Hz-20kHz, 0.08% THD)
Output Power / Channel	75W (8 ohms)