EasyManuals Logo

Denon AVR-1508 User Manual

Denon AVR-1508
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image

Getting Started Connections Setup Remote Control Multi-Zone Information Troubleshooting
ENGLISH
Recording on an External Device
(REC OUT mode)
You can listen to one program source while recording a different
program source.
1
Press <ZONE2 / REC SELECT> until “RECOUT”
appears on the display.
ZONE2 RECOUT
2
Turn <SOURCE SELECT> to choose the input source
to be recorded.
The “REC” indicator and the indicator for the selected source
light.
RECOUT SOURCE RECOUT TUNER RECOUT XM····
3
Play the program source.
For operating instructions, refer to the respective equipment’s
operating instructions.
To record FM or AM broadcasts, select the broadcast (vpage
32).
4
Start recording.
For operating instructions, refer to the respective equipment’s
operating instructions.
Other Operations and
Functions
Other Operations
To cancel, press <ZONE2 / REC SELECT>, then turn <SOURCE SELECT>
until “ZONE2 SOURCE” is displayed.
Make a test recording before starting the actual recording.
Sources selected with the REC OUT mode are output from ZONE2
as well.
In the REC OUT mode, the remote control unit’s ZONE2 mode
buttons cannot be operated.
NOTE
Recordings you make are for your personal enjoyment and should
not be used for other purposes without permission of the copyright
holder.
Digital signals are not output from the REC OUT (CDR/TAPE and
VCR) connector.
Convenient Functions
1
Press <ENTER> or [CH SELECT].
F L V o l . + 1 . 5 d B
2
Use ui, <ENTER> or [CH SELECT] to select the
speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
bOFF” can be set by pressing o when the subwoofers volume is
set to –12 dB.
Channel Level
You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
<SOURCE SELECT>
<SPEAKER A>
<SPEAKER B>
<ENTER>, op
ui
<ZONE2 / REC SELECT>
<QUICK SELECT><POWER>
uiop
[CH SELECT]
uiop
[Front]
[Rear]
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Playback

Table of Contents

Other manuals for Denon AVR-1508

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-1508 and is the answer not in the manual?

Denon AVR-1508 Specifications

General IconGeneral
HDMI Inputs2
HDMI Outputs1
Dolby DigitalYes
DTSYes
AM/FM TunerYes
Response Bandwidth10 Hz - 100 kHz
Signal-To-Noise Ratio98 dB
THD0.08%
Input Impedance47 kOhm
Input Sensitivity200 mV
Tuner TypeDigital
Preset Station Qty56
HDMI SwitchingYes
Tuning RangeFM: 87.5 - 108 MHz, AM: 522 - 1620 kHz
Audio D/A Converter24-bit / 192 kHz
Output Impedance / Channel8 Ohm
Frequency Response10 Hz - 100 kHz
Channels7.1
Power Output75W per channel (8 ohms, 20Hz-20kHz, 0.08% THD)
Output Power / Channel75W (8 ohms)

Related product manuals