Denon AVR-1508 User Manual


Getting Started Setup Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
"6%*0
"6%*0
015*$"-
065
3-
065
R
L
R
L
CD Player
Connect the cables to be used.
CD player
When using an coaxial cable for the digital audio connection, make the settings at “System Setup” – “Input
Setup” – “Digital In Assign” (vpage 22).
iPod
®
"4%3
R
L
R
L
iPod
• With the default settings, the iPod can be used connected to the VCR (iPod) connector.
• To assign the iPod to a connector other than VCR (iPod), make the settings at “System Setup” – “Input
Setup” – “iPod Assign” (vpage 23).
Use a DENON Control Dock for iPod (ASD-1R, sold separately) to connect the iPod to the AVR-1508.
For instructions on the Control Dock for iPod settings, refer to the Control Dock for iPod’s operating
instructions.
Connections

Denon AVR-1508 Specifications

General

HDMI Inputs	2
HDMI Outputs	1
Dolby Digital	Yes
DTS	Yes
AM/FM Tuner	Yes
Response Bandwidth	10 Hz - 100 kHz
Signal-To-Noise Ratio	98 dB
THD	0.08%
Input Impedance	47 kOhm
Input Sensitivity	200 mV
Tuner Type	Digital
Preset Station Qty	56
HDMI Switching	Yes
Tuning Range	FM: 87.5 - 108 MHz, AM: 522 - 1620 kHz
Audio D/A Converter	24-bit / 192 kHz
Output Impedance / Channel	8 Ohm
Frequency Response	10 Hz - 100 kHz
Channels	7.1
Power Output	75W per channel (8 ohms, 20Hz-20kHz, 0.08% THD)
Output Power / Channel	75W (8 ohms)