Getting Started Connections Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
Tone Control
Adjust the tonal quality of the sound.
Tone Defeat
Turn tone adjustments off.
[Selectable items]
ON
: Playback without tone adjustment.
OFF
: Allow tone adjustment (treble, bass).
The tone cannot be adjusted when in the DIRECT mode.
Bass
Adjust low frequency range (bass).
[Variable range]
–14dB ~ 14dB
Treble
Adjust high frequency range (treble).
[Variable range]
–14dB ~ 14dB
“Bass” and “Treble” can be set when “Tone Defeat” is set to “OFF”.
SB CH OUT (for 2-channel sources)
Determine whether to use surround back speakers.
[Selectable items]
ON
: The surround back channel signal is played.
OFF
: The surround back channel signal is not played.
SUBWOOFER ATT.
Attenuate subwoofer level when using EXT. IN mode.
[Selectable items]
ON
: The input from the subwoofer channel is attenuated.
OFF
: The input from the subwoofer channel is not attenuated.
Usually use in this mode.
Set this to “ON” if the subwoofer channel level seems too high when
playing audio signal.
Subwoofer
Turn subwoofer output on and off.
[Selectable items]
ON
: The subwoofer is used.
OFF
: The subwoofer is not used.
Default
Resets the settings to the default values.
SB CH OUT (for Multi-channel sources)
Select playback mode for surround back channels.
[Selectable items]
OFF
: No signal is played from the surround back
channels.
NON MTRX
: The same signals as those of the surround
channels are output from the surround back
channels.
MTRX ON
: The surround channel signals undergo digital
matrix processing and are output from the
surround back channels.
PL
II
x CINEMA
z1
: Decoded in Dolby Pro Logic IIx Cinema mode,
surround back signal played.
PL
II
x MUSIC
z2
: Decoded in Dolby Pro Logic IIx Music mode,
surround back signal played.
ES MTRX
z3
: DTS signal played with digital matrix processing.
ES DSCRT
z4
: Signal included in DTS-ES Discrete 6.1-channel
sources played.
z1: This can be selected when “Surround Back Speaker” is set to
“2spkrs” at “System Setup” – “Speaker Setup” setting (vpage
20).
z2: This can be selected when “Surround Back Speaker” is set to
“2spkrs” or “1spkr” at “System Setup” – “Speaker Setup”
setting.
z3: This can be selected when playing DTS sources.
z4: This can be selected when playing DTS sources including a
discrete 6.1-channel signal identification signal.
Setup
To Next Page
Loading...
