Denon AVR-2802 Operating Instructions

29
ENGLISH
Surround parameters e
MODE: (DTS NEO:6)
• Cinema
This mode is optimum for playing movies. Decoding is performed with emphasis on separation
performance to achieve the same atmosphere with 2-channel sources as with 6.1-channel sources.
This mode is effective for playing sources recorded in conventional surround formats as well, because the
in-phase component is assigned mainly to the center channel (C) and the reversed phase component to
the surround (SL, SR and SB channels).
• Music
This mode is suited mainly for playing music. The front channel (FL and FR) signals bypass the decoder
and are played directly so there is no loss of sound quality, and the effect of the surround signals output
from the center (C) and surround (SL, SR and SB) channels add a natural sense of expansion to the sound
field.
ROOM SIZE:
This sets the size of the sound field.
There are five settings: “small”, “med.s” (medium-small), “medium”, “med.l” (medium-large) and “large”.
“small” recreates a small sound field, “large” a large sound field.
EFFECT LEVEL:
This sets the strength of the surround effect.
The level can be set in 15 steps from 1 to 15. Lower the level if the sound seems distorted.
DELAY TIME:
In the matrix mode only, the delay time can be set within the range of 0 to 110 ms.
TONE CONTROL:
This can be set individually for the separate surround modes other than Direct.
However, the same contents are set for DOLBY/DTS modes.
*
2 Surround modes and parameters
Channel output
When
playing
Dolby
Digital
Signals
DIRECT
STEREO
EXTERNAL INPUT
DOLBY PRO LOGIC II
DTS NEO:6
DOLBY DIGITAL
(6.1 SURROUND)
DTS SURROUND
(DTS ES MTRX 6.1)
5/6CH STEREO
ROCK ARENA
JAZZ CLUB
VIDEO GAME
MONO MOVIE
MATRIX
C
C
C
C
C
C
C
C
C
C
C
C
C
Mode Front L/R
E
E
B
B
B
B
B
B
B
B
B
B
B
CENTER
E
E
B
B
B
B
B
B
B
B
B
B
B
SURROUND
L/R
B
B
B
B
B
B
B
B
B
B
B
B
B
SUB-
WOOFER
E
E
B
B
B
B
B
B
B
B
B
B
B
SURROUND
BACK L/R
C
C
E
C
E
C
E
E
E
E
E
E
E
When
playing
DTS
signals
C
C
E
E
E
E
C
E
E
E
E
E
E
When
playing
PCM
signals
C
C
E
C
C
E
E
C
C
C
C
C
C
When
playing
ANALOG
signals
C
C
C
C
C
E
E
C
C
C
C
C
C
C: Signal
E: No signal
B: Turned on or off by speaker configuration setting
C: Able
E: Unable
* Only for 2 ch contents
Parameter (default values are shown in parentheses)
SURROUND PARAMETER
TONE CONTROL CINEMA EQ.
ROOM SIZE
EFFECT LEVEL DELAY TIME
When playing
Dolby Digital
/ DTS signals
D. COMP LFE
DIRECT
STEREO
EXTERNAL INPUT
DOLBY PRO LOGIC II
DTS NEO:6
DOLBY DIGITAL
(6.1 SURROUND)
DTS SURROUND
(DTS ES MTRX 6.1)
5/6CH STEREO
ROCK ARENA
JAZZ CLUB
VIDEO GAME
MONO MOVIE
MATRIX
E
C
(0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
C (0dB)
E
E
E
C
(OFF)
C (OFF)
C (OFF)
C (OFF)
E
E
E
E
E
E
E
E
E
E
E
E
E
E
C
(Medium)
C (Medium)
C (Medium)
C (Medium)
E
E
E
E
E
E
E
E
E
C
(10)
C (10)
C (10)
C (10)
E
E
E
E
E
E
E
E
E
E
E
E
E
C
(30msec)
C (OFF)
C (OFF)
E
C
(OFF)
E
C
(OFF)
E
E
E
E
E
E
E
C
(0dB)
C (0dB)
E
C
(0dB)
E
C
(0dB)
C (0dB)
E
E
E
E
E
E
Mode
MODE
E
E
E
C
(CINEMA)
C (CINEMA)
E
E
E
E
E
E
E
E
EFFECT
E
E
E
E
E
E
E
E
E
E
E
E
E
LEVEL
E
E
E
E
E
E
E
E
E
E
E
E
E
SURROUND BACK
E
E
E
C
( NON MTRX )
C
( NON MTRX )
C
(MTRX ON)
C
(MTRX ON)
E
E
E
E
E
E
PANORAMA
E
E
E
C
(OFF)
E
E
E
E
E
E
E
E
E
DIMENSION
E
E
E
C
(3)
E
E
E
E
E
E
E
E
E
CENTER WIDE
E
E
E
C
(0)
E
E
E
E
E
E
E
E
E
PRO LOGIC II MUSIC
MODE ONLY
C: Adjustable
E: Not adjustable

Denon AVR-2802 Specifications

General

Impedance	8 ohms
Surround Sound	Dolby Digital, DTS, Dolby Pro Logic II
AM/FM Tuner	Yes
Remote Control	Yes
Number of Channels	6.1
Frequency Response	10 Hz - 100 kHz (+1, -3 dB)
Total Harmonic Distortion	0.05%
Power Output	90 W per channel (8 ohms, 20 Hz-20 kHz, 0.05% THD)
Video Inputs	Composite, S-Video
Video Outputs	Composite, S-Video
Signal To Noise Ratio	98 dB
Input Sensitivity	200 mV
Input Impedance	47 kOhms
Inputs	8 Analog Audio (including Phono), 5 Digital Audio (3 Optical, 2 Coaxial)