Use the D and H cursor buttons to display “RESET PRE” on
the remote control unit, then press the ENTER button.
• After “SEL PRE” is displayed on the remote control unit’s
display, the registered preset memory is displayed on the
remote control unit’s display.
Use the D and H cursor buttons to
select the code to be reset.
When the mode you want to reset is shown on the remote
control unit’s display, press the ENTER button to reset the
preset memory.
“CONFIRM” is displayed. To reset the preset memory, press
the ENTER button while “CONFIRM” is displayed.
•“COMPLETE” appears on the remote control unit’s display.
(3) Resetting “learned” buttons
Press the power ON/SOURCE button and the OFF button at
the same time.
•“SET UP” appears on the remote control unit’s display.
Press the ENTER button.
Use the D and H cursor buttons to display “RESET” on the
remote control unit’s display, then press the ENTER button.
•“RESET PRE” is displayed.
4
Use the D and H cursor buttons to display “RESET LRN” on
the remote control unit’s display, then press the ENTER
button.
•“SEL MODE” is displayed, then “TV” appears.
5
Use the D and H cursor buttons to select the mode of the
button to be reset, then press the ENTER button.
6
“CONFIRM” is displayed. To reset the “learned” button for
the selected mode, press the ENTER button while
“CONFIRM” is displayed.
To Next Page
Loading...
Need help?
General
