40
Auto search function
• The set is equipped with a function for searching for the registration
number if you do not know the preset code (a 4-digit number) when
setting the preset memory.
1
2
For TV, DBS or CABLE components, turn on the component’s
power. For CD, MD, TAPE, DVD, VCR and VDP component’s,
turn on the component’s power and load a disc or tape.
Press the power ON/SOURCE button and the OFF button at
the same time.
•“SET UP” appears on the remote control unit’s display.
If you press the power OFF button late at step 6, press the D and
H cursor button once to move to the next code or back to the
previous code one step at a time.
D button: Next code
H button: Previous code
Auto search resumes when you move ahead from the code at
which you stopped.
Press the ENTER button.
Use the D and H cursor buttons to display “AUTOSEARCH”
on the remote control unit, then press the ENTER button.
Use the D and H cursor buttons to display the mode of the
component to be searched for on the remote control unit’s
display, then press the ENTER button.
• The registration codes are transmitted in order.
When the component operates, press the POWER OFF
button.
• The mode and the registered number appear on the remote
control unit’s display.
The channel switches on the TV, DBS or CABLE device and
playback stops on a CD, MD, tape, DVD, VCR or VDP player.
Press the ENTER button.
•“COMPLETE” is displayed on the remote control unit’s
display and the selected code is preset.
To Next Page
Loading...
Need help?
General
