Denon AVR-3803

Set the distance between the
center speaker and listening
position.
The distance changes in units of
1 foot (0.1 meters) each time the
button _s pressed. Select the
value closest to the measured
distance.
Delay Time
Default [_4
Front L 12ft
, Front R 12ft
,_Center <12ft_
Example:When the distanceis setto 12 feet
forthe centerspeaker
Delay Time
:rSL A <10ft_
SR A 10ft
SL B 10ft
I_ . _1 SR B 10ft
I__ __ __1SBL 10ft
SBR 10ft
[_|=ll[eId_lll= :llllll[41_[€l [-I;I
If "Yes" is selected for "Default", the settings are automatically reset
to the default values.
Please note that the difference of distance for every speaker should be
20 ft (6.0 m} or less. If you set an invalid distance, a CAUTION notice,
such as screen right will appear. In this case, please relocate the blinking
speaker(s) so that its distance is no larger than the value shown in
highlighted line.
Front L 12ft
Front R 12ft
Center lft
__\ Enter the setting.
The System Setup Menu reappears.
The AVR-3803/1083 automatically sets the optimum surround delay time for the listening room.
NOTE:
• If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 16, 17}.
• Use this setting to adjust so that the playback level between the different channels is equal.
• From the listening position, listen to the test tones produced from the speakers to adjust the level.
• The level can also be adiusted directly from the remote control unit. (For details, see page 55.)
• When using both surround speakers A and B, their playback levels can be adjusted separately.
1
At the System Setup Menu select "Channel Level".
System Setup Menu
Speaker Configuration
Delay Time
_Channel Level
Dlgital In Assignment
Video Setup
Dolby Digital Setup
Zone2 Control
Switch to the Channel Level screen.
Select "Test Tone".
Channel Level
_Test Tone _4:_
Surr. S_ _B A+B
Test Tone Start [)_]<
Level Clear [_]4
22