Denon AVR-3803 - Page 25

NOTES:
• The OPTICAL 4 and 5 iacks on the AVR-3803/1083'S rear panel are equipped with an optical digital output jack for recording digital signals on
a CD recorder, MD recorder or other digital recorder. Use this for digital recording between a digital audio source (stereo - 2 channel) and a
digital audio recorder.
• Do not connect the output of the component connected to the OPTICAL 4 OUT jack on the AVR 3803/1083's rear panel to any jack other than
the OPTICAL 4 IN jack.
• Do not connect the output of the component connected to the OPTICAL 5 OUT jack on the AVR 3803/1083's rear panel to any jack other than
the OPTICAL 5 IN jack.
• "PHONO" and "TUNER" cannot be selected on the Digital in Assignment.
• This setting assigns the color difference (component} video input jacks of the AVR-3803/1083 for the different input sources.
[1] Setting the Component In Assign.
1
At the System Setup Menu select "Video Setup" and
press the ENTER button.
System Setup Menu
Speaker Configuration
Delay Time
Channel Level
Digital In Assignment
ErVi deo Setup
Dolby Digital Setup
Zone2 Control
2
The "Video Setup" screen appears.
Select "Component in Assign." and press the ENTER
button.
Video Setup
_Component In Assign.
Video Input Mode
Exit
4
Switch to the Component In Assign. screen.
Component In Assign.
[_: NONE
[_]: NONE
[_]: VIDEO2
[_: NONE
_: NONE
[_: NONE
Default [_
Select the component (Y, PB/C8 and PR/CR)video input terminal to be assigned to the input source.
(_ input source selection _2} Component video terminal selection
Select "NONE" for sources for which the component (Y, PB/C8 and PR/CR)video input is not to be used.
When the default, "Yes", is selected, the settings are reset to the factory defaults.
(__\ Press the ENTER button to complete the setting.
At the "Video Setup" screen, select "Exit" and press the ENTER button.
The System Setup Menu reappears.
25