Denon AVR-3803

Sets the down-mixing method when not using a center speaker or surround speakers.
OFF: The dynamic range is not compressed.
ON: The dynamic range is compressed automatically according to the combination of speakers being used.
1
At the System Setup Menu select "Dolby Digital
Setup" and press the ENTER button.
System Setup Menu
Speaker Configuration
Delay Time
Channel Level
Digital In Assignment
Video Setup
_Dolby Digital Setup
Zone2 Control
2
Select "ON" if you want to use the Compression, "OFF" if you do not
want to use it.
NOTE:
When not using a center speaker or surround speakers, the sound is
played from the front speakers. If the sound should seem distorted
because the input level exceeds the allowable input for the front
speakers, set "Compression" to "ON".
Dolby Digital
Downmix Option Setup
Compression
_:_[_
Enter the setting.
The System Setup Menu reappears.
[1] Setting the power amplifier assignment
Make this setting to switch the power amplifier for the surround back channel to ZONE2.
If ZONE2 is selected, the signal that selected at ZONE2 is output at "SURR. BACK/ZONE2 PREOUT" terminals.
1
At the System Setup Menu select "Zone2 Control"
and press the ENTER button.
System Setup Menu
Speaker Conflguration
Delay Time
Channel Level
Digital In Assignment
Video Setup
Dolby Digital Setup
_Zone2 Control
2
The "Zone2 Control" screen appears.
Select "Power Amp Assignment" and press the
ENTER button.
Zone2 Control
_Power Amp Assignment
Zone2 Vol, Level
Exit
Select "Surround Back" to use as the surround back
channel, "Zone2" to use as Zone 2 out.
Power Amp Assignment
<_TI : Zone2
When "Surround Back" is selected
Power Amp Assignment
¢SurroundBeck: F'_ll_m_
When "Zone2" is selected
27