Denon AVR-3803

_ Enter the setting.
At the "Zone2 Control" screen, select "Exit" and press the ENTER button.
The System Setup Menu reappears.
[2] Setting the Zone2 vol. level
Set the Zone 2 pre-out output level adjustment.
At the System Setup Menu select "Zone2 Control" System Setup Menu
and press the ENTER button.
Speaker Configuration
Delay Time
Channel Level
Digital In Assisnment
Video Setup
Dolby Digital Setup
7Zone2 Control
2
The "Zone2 Control" screen appears.
Select "Zone2 VoL Level" and press the ENTER
button.
Zone2 Control
Power Amp Assisnment
_Zone2 Vol. Level
Exit
Select the desired settimg.
Variable:
The level can be adjusted freely using the buttons on the remote control
unit.
0 dB, -40 dB:
The output level is fixed at the set level and the volume can no longer be
adjusted.
Zone2 Vol. Level
K_ _ -40dB OdB
_\ Enter the setting.
At the "Zone2 Control" screen, select "Exit" and press the ENTER button.
The System Setup Menu reappears.
This function allows you to adjust the time delay of the video and audio signals and store these settings for the different input sources.
The setting is made while watching a DVD or other software, so it is not made here.
By default, this is not displayed when no digital signals are being input.
For instructions on making the setting, refer to page 61.
NOTE:
The audio delay setting does not apply when playing in the EXT. IN mode or in the analog input direct mode or stereo mode (TONE DEFEAT "ON").
28