Denon AVR-3803

• Set the method of playback of the analog input signal connected to the Ext.ln Subwoofer.
1
At the System Setup Menu select "Ext.ln Subwoofer Level".
System Setup Menu
Audio Delay
7Ext. In Subw00ferLevel
Auto Surround Mode
On Screen Display
Trigger Out Setup
Auto Tuner Presets
Setup Lock
Switch to the Ext.ln Subwoofer Level screen.
Ext, In Subw0oferLevel
Subw00ferLebel <+15dB_
Select the desired setting.
Select according to the specifications of the player being used. Also refer to the player's operating instructions.
+15dB {default) recommended. (0, +5, 10 and +15 can be selected.)
(_,_ Enter the setting.
The System Setup Menu reappears.
The surround mode used at last for the four types of input signals shown below is stored in the memory, and the signal is automatically played
with that surround mode the next time it is input.
Note that the surround mode setting is also stored separately for the different input sources.
_ Analog and PCM 2-channel signals
_2_ 2-channel signals of Dolby Digital, DTS or other multi-channel format
_3_ Multi-channel signals of Dolby Digital, DTS or other multi-channel format
_ Multi-channel signal when conducting playback using the EX_.IN
,_ During playback in the PURE DIRECT mode, the surround mode does not change even if the input signal is changed.
1
At the System Setup Menu select "Auto Surround
Mode" and press the ENTER button.
System Setup Menu
Audio Delay
Ext, In Subwo0ferLevel
_Auto Surround Mode
On Screen Display
Trigger Out Setup
Auto Tuner Presets
Setup Lock
29