Denon AVR-3803

NOTES: of
• The remote control signals of the buttons pressed while registering the system call signals are emitted, so be careful not to operate the
components accidentally (cover the remote sensors, for example).
• If you exceed the number of signals that can be registered, "FULL" appears on the remote control unit's display and only the number
signals that can be registered are registered (up to 10 operations).
13)Using the system call function
Press the button at which the system carl signals have been stored.
• The stored signals are transmitted successively.
(1) Punch through button
Buttons used in the CD, CDR, TAPE, DVD, VDP, VCR1 and VCR2
modes can be assigned to the buttons shown on the diagram at
the right which are not normally used in the AMP, TV, DBS and
CABLE modes.
For example, when the CD mode is set to the punch through mode
in the AMP mode, the CD mode's PLAY, STOP, MANUAL
SEARCH, AUTO SEARCH, PAUSE and DISC SKIP buttons' signals
are sent in the AMP mode.
(2) Making the punch through setting
1
Press the power ON/SOURCE button and the OFF button at
the same time.
• "PRE" appears on the remote control unit's display.
OFF 0N/S01JF_
Use the • and • cursor buttons to display "PUNCH" on the
remote control unit, then press the ENTER button.
• "SEL" appears on the remote control unit's display.
Use the • and • cursor buttons to display the mode for which
you want to make the punch through setting, then press the
ENTER button.
• "SEL" appears on the remote control unit's display.
The display switches as shown below each time the • and
• cursor buttons are pressed.
_-AMP-_,- DBS-_-CABLE-_-TV _]
It is also possible to select the mode directly using the
mode buttons.
(1)
2,3,4
1
OOOO
i .
o NN_
_t
1
2,3,4
Use the • and • cursor buttons to display the mode you want
to punch through, then press the ENTER button.
• "OK" is displayed and the punch through is set.
The display switches as shown below each time the • and
• cursor buttons are pressed.
vCDR MD"-TAPE DVO
CR2_ VCR1 _'VD P
It is also possible to select the mode directly using the
mode buttons.
41