Denon AVR-3803

(3) Resetting the system call buttons
1
Press the power ON/SOURCE button and the OFF button at
the same time.
• "PRE" appears on the remote control unit's display.
OFF QN/_IJR_
2
Use the • and • cursor buttons to display "RST" on the
remote control unit, then press the ENTER button.
• "PRE" appears on the remote control unit's display.
Use the • and • cursor buttons to display "CALL" on the
remote control unit, then press the ENTER button.
• "SEL" appears on the remote control unit's display.
4
Press the • and • cursor buttons to select the system carl
setting to be reset.
The remote control unit's display switches as shown
below each time the • and • cursor buttons are pressed.
S S0ALL,'
SYS CALL 2
To reset CALL 1 or CALL 2, select "CALL 1" or CALL 2", then
press the ENTER button.
• The LCD's back light flashes during the resetting operation,
and when the operation is completed, "OK" is displayed
and the set returns to the normal operating mode.
2,3,4
1
0 _N_
1
2,3,5
44