Denon AVR-3803

4
Use the • and • cursor buttons to display "PRE" on the
remote control unit, then press the ENTER button.
• After "SEL" is displayed on the remote control unWs
display, the registered preset memory is displayed on the
remote control unit's display.
Use the • and • cursor buttons to
select the code to be reset.
When the mode you want to reset is shown on the remote
control unit's display, press the ENTER button to reset the
preset memory.
• The LCD's back light flashes during the resetting operation,
and when the operation is completed, "OK" is displayed
and the set returns to the normal operating mode.
(2) Resetting "learned" buttons
1
Press the power ON/SOURCE button and the OFF button at
the same time.
• "PRE" appears on the remote control unit's display.
OFF ON/SOUR¢E
Use the • and • cursor buttons to display "RST" on the
remote control unit's display, then press the ENTER button.
• "PRE" is displayed.
Use the • and • cursor buttons to display "LRN" on the
remote control unit's display, then press the ENTER button.
• "SEL" is displayed.
1
2,3,4
Q_
OOOO
o NNON
iE.gl
1
2,3,4
4
Use the • and • cursor buttons to select the mode of the
button to be reset, then press the ENTER button.
• The LCD's back light flashes during the resetting operation,
and when the operation is completed, "OK" is displayed
and the set returns to the normal operating mode.
43