Denon AVR-3803

[5] Checking the currently playing program source, etc.
1
On screen display
• Each time an operation is performed,
a description of that operation
appears on the display connected to
the unit's VIDEO MONITOR OUT ONSCF_EN
jack. ALSO,the unit's operating status
can be checked during playback by
pressing the remote control unit's ON
SCREEN/DISPLAY button.
Such information as the position of
the input selector and the surround
parameter settings is output in
sequence.
Front panel display
• Descriptions of the unit's operations
are also displayed on the front panel STATUS
display. In addition, the display can be
switched to check the unit's L_.
operating status while playing a
source by pressing the STATUS
button.
{Remote cohtro_ urfit)
{Main unit)
[6] Switching the surround speakers
:: 11
Using the dimmer function
• Use this to change the brightness of the display.
The display brightness changes in four steps
(bright, medium, dim and off) by pressing the
main unit's DIMMER button repeatedly.
DIMMER
(Main unit}
I
The surround speakers switch as
shown below each time the SPEAKER
button is pressed.
{Remote cor_tro_ unit)
-_ This operation is possible when the setting for using both
surround speakers A and B is made at "Speaker
Configuration" in the System Setup Menu.
mm_ --
[1] Playing one source while recording another (REC OUT mode)
1
Press the ZONE2/REC button.
ZONE 2
/REC
{Main unit)
2
With "RECOUT SOURCE" displayed,
turn the FUNCTION knob to select the tO _
source you wish to record.
• The "REC" indicator and the
indicator of the selected source
light.
{Main unit}
Set the recording mode.
• For operating instructions, refer to the manual of the
component on which you want to record.
To cancel, turn the function knob and select "SOURCE".
• When "SOURCE" is selected, the "REC" indicator turns
off.
F _cTI_
(Ivla_n unitl
2,4
1
2
I
Display 2
I
[":.E:.L..,L.._L.._i .:::,L.._L.._[":.L..,E:.
NOTES:
• Recording sources other than digital inputs selected in the REC
OUT mode are also output to the Zone 2 preout jacks.
• Digital signals are not output from the REC SOURCE or audio
output jacks.
52