Denon AVR-3803

• Operating the surround mode and surround parameters from the main unit's panel.
1
Turn the SELECT knob to select the surround mode.
SELECT
(Main unit)
• When turned clockwise
m
O/r
oooo .,
1 2 1,3
• When turned counterclockwise
To select the surround mode while adjusting the surround parameters or tone control, press the surround mode button then operate
the selector.
SURROUND
MODE
2
(Mainunit)
Press the SURROUND PARAMETER button.
Press and hold in the surround parameter button to select the parameter you want to set.
• The parameters which can be set differ for the different surround modes. (Refer to "Surround Modes and Parameters" on page 67.)
SURROUND
pA_IE_ER
(Main unit)
Display the parameter you want to adjust, then turn the SELECT knob to set it.
NOTE:
• When playing PCM digital signals or analog signals in the DOLBY PRO LOGIC H, DTS NEO:6 modes and the input signal switches to a digital
signal encoded in Dolby Digital, the Dolby surround mode switches automaticafly. When the input signal switches to a DTS signal, the mode
automatically switches to DTS surround.
64