Denon AVR-3803S User Manual

ENGLISH
RECORDING
e Switch on your amplifier or receiver and the source com-
ponent.
eSet the Tape Monitor switch on your amplifier or receiver
to the SOURCE position.
feels se sa et
DENON
pnccision
aun
component
/STengo
CASSETTE
TaPEDECK
ORS~810
‘DOUBLE
DOLRY
SYSTEM
ee ee ee
= 8888 See
HORIZONTAL LoaoING SYSTEM I—HEAD croseo Love nuaL cAPSTAN a § aEDEASORAREESBBORERSOOSS
emo num = Onc > wx BS OOS 5 GReE
@
Press
the
POWER
switch
to
the
ON
(
=
)
position.
Caution:
e Be careful
not
to
erase
important
recordings
by
mistake.
®
Press
the
OPEN/CLOSE
button
and
set
the
cassette
in
Inadvertent
start
of
recording
will
happen
in
the
following
the
cassette
tray.
eeeus
Cases,
1. If the PLAY button is pressed while the © indicator
lights, recordin starts.
2. If the PLAY (B®) and REC/REC MUTE (@) button are
. pressed at the same time, recording starts.
The best way to avoid accidental erasure is to break offthe
two erasure prevention tabs on the cassette housing.
Cassette tray
(Check that the accidental erasure prevention tabs are
intact.) REC RETURN Button
Use of the recording return function is convenient when re-
recording or when cancelling a recording. When pressed
during recording, the tape is rewound to the position where
@
Press
the
DOLBY
NR
button
and
select
the
Dolby
NR
type
that
suits
the
recording.
Recording
with
Dolby
NR
type
B
recording
started,
and
the
deck
will
enter
the
recording
(The indicator will light up.) standby mode.
Recording with Dolby NR type C Cautions:
(ibe
indicator
will
light
up.)
The
return
position
arrived
at
with
the
recording
return
Recording
without
Dolby
NR
function
will
be
where
rewinding
has
continued
abot
2
|
seconds beyond the recording start position. Cautionis in
order here since it is possible that the end of the previous
@ Pressthe REC/REC MUTE (@) button to set the recording selection might be erased on tapes that have been
pause mode. The Olt indicator will light up. recorded without at least 5 seconds of blank spices
between the songs.
® Adjust the recording level with the INPUT LEVEL control
while watching the Peak Level Meter, than adjust the
balance of the left and right channels with the BALANCE
control.
Press the PLAY button to start the recording.
The PLAY ( [>) and the Oindicator will light during
recording.
@ To stop recording, press the STOP (M) button.
@
To pause the recording, press the PAUSE (41) button.
Press the PLAY button to resume recording.

Denon AVR-3803S Specifications

General

Brand	Denon
Model	AVR-3803S
Category	Tape Deck
Language	English