Getting Started Connections Setup Information Troubleshooting
ENGLISH
Specications
iPod
®
Playback
The music on an iPod can be played by using the control dock
for iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W, sold separately).
The operation can also be performed using the buttons on the
remote control unit.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
1
Make the necessary preparations.
q Set the iPod in the DENON control dock for iPod.
(vSee the control dock for iPod’s operating instructions.)
w Assign the control dock for iPod’s input.
The input for the control dock for iPod is assigned to VCR by
default.
“iPod Assign” – “Assign” (vpage 16)
2
Press <INPUT SELECT> or [VCR (iPod)] to select the
input source assigned in step 1-w above.
3
Press [SEARCH] and hold it down for a 2 seconds or
more to select the display mode.
To switch between modes, press and hold down the button.
When remote mode is active, “REMOTE” is displayed.
[Display mode]
Browse mode Remote mode
Display location Main unit display
iPod display
Playable
files
Audio file
S S
Video file
S
z
1
S
z
2
Active
buttons
Remote
control unit
(AVR-390)
S S
iPod
A S
z
1
: When using an ASD-3N or ASD-3W control dock for iPod.
z
2
: Video may not be output, depending on the combination of
ASD-1R or ASD-11R and iPod.
Preparations
• With the default settings, the iPod can be used connected to the
VCR (iPod) connector.
• Press <ON/STANDBY> or [POWER OFF] and set the AVR-390’s power
to the standby mode before disconnecting the iPod. Also switch the
input source to one to which “iPod Assign” is not assigned before
disconnecting the iPod.
• When using an ASD-3N or ASD-3W control dock for iPod, refer to
the respective manual to operate.
• When you wish to output iPod video to a monitor, connect the
S-Video output of the control dock for iPod to the S-Video input
terminal (DVD or VCR) of AVR-390.
Listening to Audio
1
Use [ui] to select the item, then press [ENTER] or
[p] to select the music le to be played.
2
Press [ENTER] or [p].
Playback starts.
Button located on both the main unit and the remote
control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
ui
STATUS
<INPUT SELECT>
<ON/STANDBY>
d
f
[
1
/
3
]
[
9
]
[SEARCH]
[
uip
]
[ENTER]
STATUS
[VCR (iPod)]
[POWER OFF]
[REPEAT]
[
2
]
[
8
]
[
6
]
[RANDOM]
[
7
]
Playback
To Next Page
Loading...
Need help?
General
