Denon AVR-4306 - Page 9

06.April.06
9/28
COMMAND PARAMETER
function example
Z2 UP MULTI ZONE-2 VOLUME UP/DOWN , direct change to **dB Z2UP<CR>
DOWN at AVR-4306 Z2DOWN<CR>
** **:10 to 99 by ASCII , 80=0dB, 99=---(MIN) Z280<CR>
ON MULTI ZONE-2 ON/OFF change at AVR-4306 Z2ON<CR>
OFF Z2OFF<CR>
? Request Z2 Status Z2?<CR>
Z2MU ON ZONE2 OUTPUT MUTE ON/OFF change Z2MUON<CR>
OFF Z2MUOFF<CR>
? Request Z2MU Status Z2MU?<CR>
Z3 PHONO MULTI ZONE-3 mode set , and select source at AVR-4306 Z3PHONO<CR>
| ---The name of PARAMETER is  |
AUXIPOD the same as that of the time of SI COMMAND. Z3AUXIPOD<CR>
SOURCE MULTI ZONE-3 mode cancel Z3SOURCE<CR>
UP MULTI ZONE-3 VOLUME UP/DOWN , direct change to **dB Z3UP<CR>
DOWN Z3DOWN<CR>
** **:10 to 99 by ASCII , 80=0dB, 99=---(MIN) Z380<CR>
ON MULTI ZONE-3 ON/OFF change at AVR-4306 Z3ON<CR>
OFF Z3OFF<CR>
? Request Z3 Status Z2?<CR>
Z3MU ON ZONE3 OUTPUT MUTE ON/OFF change Z3MUON<CR>
OFF Z3MUOFF<CR>
? Request Z3MU Status Z3MU?<CR>
SR PHONO REC SELECT mode set , and select source SRPHONO<CR>
| ---The name of PARAMETER is |
AUXIPOD the same as that of the time of SI COMMAND. SRAUXIPOD<CR>
SOURCE REC SELECT mode cancel SRSOURCE<CR>
? Request SR Status SR?<CR>
Z3 COMMAND : "*" parameter uses two ASCII characters. (see page4 J) section)