Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting Specifications
Symptom Cause Countermeasure Page
Cannot connect
to network.
• The settings of the SSID
and network key (WEP) are
incorrect.
• The reception is poor and the
signals cannot be received.
• There are multiple networks and
the usable channels overlap.
• Match the network settings with
the AVR-4308CI’s settings.
• Shorten the distance from the
wireless LAN’s access point,
remove any obstacles and
otherwise improve visibility, then
try reconnecting. Also install
away from microwave ovens
and the access points of other
networks.
• Set the access point’s channel
settings away from the channels
used for other networks.
Alternatively, connect using a
network cable.
33 ~ 35
–
–
Played sound is
interrupted or
sound cannot be
played.
• There are multiple networks and
the usable channels overlap.
• Set the access point’s channel
settings away from the channels
used for other networks.
Alternatively, connect using a
network cable.
–
GWireless LANH GXM Satellite RadioH
Symptom Cause Countermeasure Page
“CHECK XM
TUNER” is
displayed.
• The XM Mini-Tuner is not
installed or not fully seated in the
XM Mini-Tuner Dock or the XM
Mini-Tuner dock is not connected
to the AVR-4308CI.
• Confirm the XM Mini-Tuner is
fully seated in the dock and check
the XM Mini-Tuner dock cable is
connected to the AVR-4308CI.
18
”CHECK
ANTENNA” is
displayed.
• AVR-4308CI’s XM connector and
the XM Mini-Tuner and Home
Dock is not properly connected.
• Check that the connections are
correct.
18
”NO SIGNAL” is
displayed.
• The signal cannot be received. • Reposition your XM Mini-Tuner
and Home Dock antenna.
52
”OFF AIR” is
displayed.
• The selected channel is not
currently broadcasting.
• Select another channel. –
Receiving only
XM channels 0
and 1.
• The XM Mini-Tuner is not
activated.
• Contact XM Radio. –
“XM - - - ” is
displayed.
• The selected channel is not
available. The channel may have
been reassigned to a different
channel number. This message
may occur initially with a new
radio or a radio that has not
received XM’s signal for an
extended period.
• Consult the latest channel
guide at www.xmradio.com or
www.xmradio.ca for the current
list of channels. For cases of
a new radio or a radio that has
not received XM’s signal for an
extended period, allow the radio
to receive the XM satellite signal
for at least 5 minutes and then
try to select the channel again.
–
“UPDATING” is
displayed.
• You selected an XM channel that
is blocked or cannot be received
with your XM subscription
package.
• Consult the latest channel
guide at www.xmradio.com or
www.xmradio.ca for the current
list of channels. For information
on receiving this channel,
visit www.xmradio.com or
www.xmradio.ca contact XM
Satellite Radio at 1-800-967-2346
or 1-877-438-9677.
–
Troubleshooting
To Next Page
Loading...
