Denon AVR-4802 Control Protocol

- 10 -
EVENT PARAMETER function example *RES.
ZM ON MAIN-ZONE ON/OFF change ZMON<CR>
OFF ZMOFF<CR>
Z1 PHONO MULTI ZONE-1 source change Z1PHONO<CR>
| ---The name of PARAMETER is |
MD/TAPE2 the same as that of the time of SI COMMAND. Z1MD/TAPE2<CR>
SOURCE MULTI ZONE-1 mode cancel Z1SOURCE<CR>
** MULTI ZONE-1 VOLUME change , **:00 to 99 by ASCII Z180<CR> *
98 = +18dB(MAX)
80 = 0dB
10 = -70dB
00 = ---(MIN)
ON MULTI ZONE-1 ON/OFF change Z1ON<CR> *
OFF Z1OFF<CR> *
---means MULTI ZONE functions at AVR-4802
Z2 PHONO MULTI ZONE-2 source change Z2PHONO<CR>
| ---The name of PARAMETER is |
MD/TAPE2 the same as that of the time of SI COMMAND. Z2MD/TAPE2<CR>
SOURCE MULTI ZONE-2 mode cancel Z2SOURCE<CR>
** MULTI ZONE-2 VOLUME change , **:00 to 99 by ASCII Z180<CR> *
98 = +18dB(MAX)
80 = 0dB
10 = -70dB
00 = ---(MIN)
ON MULTI ZONE-2 ON/OFF change Z2ON<CR> *
OFF Z2OFF<CR> *
---Invalid at AVR-4802
SR PHONO REC SELECT source change SRPHONO<CR>
| ---The name of PARAMETER is |
MD/TAPE2 the same as that of the time of SI COMMAND. SRMD/TAPE2<CR>
SOURCE REC SELECT mode cancel SRSOURCE<CR>
TF ****** (6 digits) TUNER Frequency change TF105000<CR>
--- ****.** kHz at AM band (1050.00kHz at AM)
****.** MHz at FM band

Denon AVR-4802 Specifications

General

Impedance	8 ohms
Frequency Response	10 Hz - 100 kHz (+1, -3 dB)
THD	0.05%
Signal-to-Noise Ratio	100 dB
Surround Sound	Dolby Digital, DTS, Dolby Pro Logic II
Component Video Inputs	3
Digital Inputs	5 (3 Optical, 2 Coaxial)
Type	AV Receiver
Channels	7.1
Input Impedance	47 kOhms
Input Sensitivity	200 mV
Inputs	5 Digital (3 Optical, 2 Coaxial)
Outputs	composite video, component video, optical digital
Audio D/A Converter	24-bit/192kHz