Denon AVR-4806 - Getting Started: Remote Control Details; Remote Control Unit Layout; Remote Control Button Groupings

- 12 -
TF, TP, TM COMMAND : '*' parameters can NOT operate when INPUT source isn’t TUNER.
EVENT PARAMETER
function example
TF UP TUNER Frequency UP/DOWN , direct change TFUP<CR> *
DOWN TFDOWN<CR> *
****** (6 digits) --- ****.** kHz at AM band (>050000 is AM.)
****.** MHz at FM band (<050000 is FM.)
TF105000<CR>
(1050.00kHz at AM)
XM***
(channel No.)
--- *** at XM mode TFXM001<CR>
(channel 1 at XM)
TP UP TUNER PRESET CH UP/DOWN , direct change to No.** TPUP<CR>
DOWN TPDOWN<CR>
**(PRESET No.) TPA1<CR>
(PRESET No.”A1”)
TM TUNER BAND , MODE Select
AM ---Band set to AM TMAM<CR>
FM ---Band set to FM TMFM<CR>
XM ---Band set to XM TMXM<CR>
AUTO ---Tuning mode set to AUTO mode TMAUTO<CR> *
MANUAL ---Tuning mode set to MANUAL mode TMMANUAL<CR> *