To Next PageTo Next Page
What to do if my Denon Stereo Receiver amplifier circuit has failed?
If the power display on your Denon Stereo Receiver flashes red at 0.5-second intervals, it indicates that the amplifier circuit has failed. Switch off the power and contact the DENON service advisor.
Why does my Denon Stereo Receiver power not turn on?
If your Denon Stereo Receiver isn't turning on, or turns off immediately after being turned on, check that the power plugs are securely inserted into the receiver's AC inlet and the wall power outlet.
Why can't I record a picture with my Denon Stereo Receiver?
The REC OUT video terminal on your Denon Stereo Receiver doesn't have a video conversion function. Use a video cable for video signals and an S-Video cable for S-Video signals.
Why can't I find the server on my Denon Stereo Receiver?
If your Denon Stereo Receiver can't find the server or connect to it: * Check the computer’s or router’s firewall settings. * Ensure the computer is turned on. * Verify the server is running. * Check the receiver’s IP address.
General| Channels | 9.2 |
|---|---|
| Total Harmonic Distortion (THD) | 0.05% |
| Frequency Response | 10 Hz - 100 kHz |
| HDMI Inputs | 6 |
| HDMI Outputs | 2 |
| Response Bandwidth | 10 Hz - 100 kHz |
| Signal-To-Noise Ratio | 102 dB |
| Input Impedance | 47 kOhm |
| Input Sensitivity | 200 mV |
| HD Radio | Yes |
| HDMI Switching | Yes |
| Video Upconversion | Yes |
| Network Connectivity | Yes |
| Bluetooth | No |
| AirPlay | No |
| DLNA Certified | Yes |
| Radio Tuner | AM/FM |
| Audio Formats Supported | Dolby TrueHD, DTS-HD Master Audio |
| Audio D/A Converter | 192kHz/24-bit |
| Video Upscaling | Yes |
| Supported Video Formats | 1080p |
| Dimensions (W x H x D) | 17.1 inches |
| Power Output (8 ohms) | 140 Watts |
