ENGLISH
Record Player
• When connecting a record player with an MC cartridge, use a commercially available MC head amplifier
or a step-up transformer.
• Induction humming (a booming sound) may be produced from the speakers if the volume is raised with
no record player connected.
• With some record players, noise may be generated when the ground wire is connected. If so, disconnect
the ground wire.
Turntable (MM cartridge)
NOTE
The AVR-888’s SIGNAL GND terminal is meant to reduce noise when a record player is connected. This is
not a safety ground terminal.
R
L
R
L
"6%*0
"6%*0
$0"9*"-
065
3-
065
CD Player
Connect the cables to be used.
CD player
When using an optical cable for the digital audio connection, make the settings at menu “Input Setup”
– “Assign” – “Digital In” (vpage 35).
ConnectionsGetting Started Setup Playback Remote Control Multi-Zone Information Troubleshooting
Getting Started Connections Setup Playback Remote Control Multi-Zone Information TroubleshootingGetting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
1.AVR888E3_ENG_1st.indd 16 2007/07/18 21:52:24
To Next Page
Loading...
Need help?
General
