Getting Started Connections Settings Remote ControlZONE2 Information Troubleshooting Specifications
ENGLISH
Playback
Playing Components
The following describes the procedure for playing Blu-ray disc player /
DVD player. Use the same procedure to play other components.
Playing a Blu-ray Disc Player/DVD Player
1
Playback preparation.
q Turn on the power of the TV, subwoofer and player.
w Switch the TV’s input to the AVR-990.
e Load the disc in the player.
2
Turn the AVR-990 power on.
(vpage 23 “Turning the Power On“)
3
Press [SOURCE SELECT] and select the input source.
Display the “SOURCE SELECT” menu (vpage 26).
4
Play the component connected to the AVR-990.
Make the necessary settings on the player (language setting,
subtitles setting, etc.) beforehand.
5
Adjust the items below.
Adjusting the master volume (vpage 65)
Selecting the surround mode (vpage 67)
Adjusting the Sound and Picture Quality
(vpage 69)
n
n
n
Before starting playback, make the connections between the different
components and the settings on the receiver.
[DEVICE
SELECT 1]
[DEVICE
SELECT 2]
[SOURCE
SELECT]
[DVD]
[iPod]
[1]
[OFF]
[SEARCH]
uio p
ENTER
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Important Information
NOTE
Also refer to the operating instructions of the connected components
when playing them.
External devices can be controlled by remote control unit (vpage
84 “Operating the Connected Devices by Remote Control Unit”).
•
•
When a DENON control dock for iPod (ASD-1R or ASD-11R, sold
separately) is used, you can play images and music stored on an
iPod
®
.
iPod
®
Playback
1
Playback preparation.
q Connecting the DENON control dock for iPod to the AVR-990
(vpage 15 “Control Dock for iPod”).
w Set the iPod
®
in the DENON control dock for iPod.
e Set [DEVICE SELECT 1] to “MAIN/TV” [DEVICE SELECT 2] to
“MAIN”.
2
Turn the AVR-990 power on.
(vpage 23 “Turning the Power On”)
3
Press [SOURCE SELECT] to display the GUI Source
Select menu, then select “ ” (vpage 26).
The input source switches to the source to which the control
dock for iPod is assigned and the iPod menu is displayed.
– GUI screen –
(When using an ASD-1R) (When using an ASD-11R)
When using an ASD-11R, the “Music” and “Videos” folders are
displayed on the top menu.
Once communications between the AVR-990 and the iPod are
completed, the connections screen is displayed on the iPod.
If the connections screen is not displayed, the iPod may not be
properly connected. Reconnect it.
b
b
b
Listening to music on an iPod
®
Front Rear
iPod is a trademark of Apple Inc., registered in the U.S. and other
countries.
The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
b
Playback
uio p
<STATUS>
ENTER
<ON/STANDBY>
To Next Page
Loading...
Need help?
General
