Getting Started Connections Settings Remote ControlZONE2 Information Troubleshooting Specifications
ENGLISH
Adjusting the Sound and Picture Quality (Audio/Video Adjust)
Setting items Setting contents
Audyssey Settings
(Continued)
Dynamic Volume : Solves the problem of large variations in volume level
between TV, movies and other content (between quiet passages and loud
passages, etc.) by automatically adjusting to the user’s preferred volume
setting.
ON : Use the “Dynamic Volume” equalizer. The Dynamic Volume effect
will be at the level of the “Setting” (vpage 72).
OFF : Do not use the “Dynamic Volume” equalizer.
“ ” is displayed when set to “ON”.
When “MultEQ” is set to “OFF”, “Dynamic Volume” is automatically
set to “OFF”.
You can also press DYNAMIC VOLUME to set.
•
•
•
•
•
Operation on the main unit
Dynamic EQ / Volume : ON
“Green” “Red”
Dynamic EQ : ON / Volume : OFF
Dynamic EQ / Volume : OFF
Operation on the remote control unit
Dynamic EQ / Volume : ON
“Green” “Red”
Dynamic EQ : ON / Volume : OFF
About Dynamic Volume
Audyssey Dynamic Volume™ solves the problem of large variations in
volume level between television programs, commercials, and between
the soft and loud passages of movies.
Audyssey Dynamic EQ™ is integrated into Dynamic Volume so that
as the playback volume is adjusted automatically, the perceived bass
response, tonal balance, surround impression, and dialog clarity remain
the same.
Setting : Set “Dynamic Volume” equalizer effect.
Midnight : High setting affects volume the most, causing all sounds to
be of equal loudness.
Evening : Middle setting prevents loud and soft sounds from being
much louder and softer respectively than average sounds.
Day : Low setting provides the least adjustments to the loudest and
softest of sounds.
Can be set when “Dynamic Volume” is set to “ON”.
•
•
•
“Green” “Red”
Setting items Setting contents
Manual EQ
Use the graphic equalizer
to adjust the tone of each
speaker.
Adjust CH : Correct the tone of each speaker.
q Select the speaker tone adjustment method.
All : Adjust the tone of all speakers together.
L/R : Adjust the tone of left and right speakers together.
Each : Adjust the tone of each speaker.
w Select the speaker.
e Select the adjustment frequency band.
63Hz / 125Hz / 250Hz / 500Hz / 1kHz / 2kHz / 4kHz / 8kHz / 16kHz
Select the speakers you want to adjust when “L/R” or “Each” is
selected.
r Adjust the level.
–20.0dB ~ +6.0dB (0.0dB)
Can be set when the “MultEQ” setting (vpage 71) is “Manual”.
b
Base Curve Copy : Copy “Audyssey Flat” curve from MultEQ.
Yes : Copy.
No : Do not copy.
“Base Curve Copy” is displayed after Audyssey Auto Setup procedure
has been performed.
Default : Reset the settings to the default values.
Yes : Reset.
No : Do not Reset.
If you select “Default” and press ENTER the message “Default
Setting?” is displayed. Select “Yes” or “No”, and then press ENTER.
•
•
Remote control operation
buttons
:Displaying the menu
Cancel the menu
:Moves the cursor
(Up/Down/Left/Right)
:Confirm the setting :Return to previous menu
“Green” “Red”
Playback
See overleaf
To Next Page
Loading...
Need help?
General
