Denon AVR-A1H User Manual

.
Sound mode
Channel output
Front
L/R
Center
Surround
L/R
Surround
Back
L/R
Front
Wide
L/R
Front
Height
L/R
Top Front
L/R
Top
Middle
L/R
Top Rear
L/R
Rear
Height
L/R
Surround
Height
L/R
Center
Height
Top
Surround
Front
Dolby
Atmos
Enabled
L/R
Surround
Dolby
Atmos
Enabled
L/R
Back
Dolby
Atmos
Enabled
L/R
Subwoofer
Multi Ch Stereo
SDDDz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 D z8z12 D z8z12 Dz11 Dz11 Dz11 D
Rock Arena
SDDDz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 D z8z12 D z8z12 Dz11 Dz11 Dz11 D
Jazz Club
SDDDz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 D z8z12 D z8z12 Dz11 Dz11 Dz11 D
Mono Movie
SDDDz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 D z8z12 D z8z12 Dz11 Dz11 Dz11 D
Video Game
SDDDz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 D z8z12 D z8z12 Dz11 Dz11 Dz11 D
Matrix
SDDDz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 Dz11 D z8z12 D z8z12 Dz11 Dz11 Dz11 D
Virtual
S D
z1
The applicable sound mode includes “Dolby Surround” and sound modes that have “+Dolby Surround” in the sound mode name.
z2
Audio can be played through a maximum of 11-channels when 11 speakers or more (excluding the subwoofer) are installed.
z3
The applicable sound mode includes “DTS Neural:X” and sound modes that have “+Neural:X” in the sound mode name.
z4
The applicable sound mode includes “DTS Virtual:X” and sound modes that have “+Virtual:X” in the sound mode name.
z5
A signal for each channel contained in an input signal is output as audio.
z6 Audio is output when “Subwoofer Mode” in the menu is set to “LFE+Main”. (v p. 251)
z7 Audio is not output when “Speaker Config.” - “Surr. Back” in the menu is set to “1 spkr”. (v p. 243)
z8
When “Speaker Config.” - “Surr. Back” is set to “2 spkrs”, “Speaker Config.” - “Center” is set to “Large” or “Small”, and sound mode is set to “IMAX DTS”, surround audio
is output from the surround back speaker. Audio is not output from the surround speaker. (v p. 243)
z9
For the best Auro-3D experience Surround Height speakers are recommended, however you may substitute Rear Height speakers from a Dolby Atmos speaker setup in
place of Surround Height speakers.
z10
For the best Auro-3D experience Front Height and Surround Height speakers are recommended, however you may substitute Dolby Atmos Enabled speakers.
z11 Audio is output from the speakers specified in the “Surround Parameter” – “Speaker Select” settings. (v p. 192)
z12
Audio is not output when connecting to the HEIGHT4/FRONT WIDE speaker terminal to use the Center Height or Top Surround speaker.
Contents
Connections Playback Settings Tips Appendix
330
Front panel Display Rear panel Remote Index

Denon AVR-A1H Specifications

General

Brand	Denon
Model	AVR-A1H
Category	Stereo Receiver
Language	English