2. PANEL / REMOTE LOCK Selection Mode
2.1. Actions
Switch the PANEL LOCK and REMOTE LOCK modes between on and off.
•  PANEL LOCK Mode (with Volume)
   Disables reception from all keys and encoders on the front panel except the power button (including 
the volume).
•  PANEL LOCK Mode (without Volume)
   Disables reception from all keys and encoders on the front panel except the power button and 
volume encoder.
•  PANEL LOCK mode is turned off
2.2. Starting up
While holding down buttons "
TUNER PRESET CH +
" and "
ZONE2 SOURCE
" simultaneously, press the 
power button to turn on the power.
Select the desired mode using the "
TUNER PRESET CH +/-
" button, then press the "
STATUS
" button 
to conrm.
2.3. Displaying and Selecting Each Mode
The information shown on the display switches each time the "
TUNER PRESET CH +/-
" button is 
pressed.
Press the "
STATUS
" button to set the currently displayed mode and restart the device.
The setting with "
*
" is selected for each mode.
q
 
 FP/VOL LOCK*On 
         The buttons on the unit and the master volume knob does not function.
                   
w
 
 FP LOCK     On 
        The buttons on the unit does not function.
                   
e
 
 FP LOCK     Off
        The PANEL LOCK mode is turned off.
                   
r
 
 RC LOCK     On 
        The device cannot be operated by the remote control.
                   
t
 
 RC LOCK    *Off
        The REMOTE LOCK mode is turned off.
    
Before Servicing 
This Unit
Electrical Mechanical Repair Information Updating
131